Adjusting The Cut-Off Frequency Value And The Slope Value; Settings - Pioneer DEH-S4000BT Manual De Instrucciones

Adjusting the cut-off frequency value and the slope
value
You can adjust the cut-off frequency value and the slope value of each speaker.
The following speakers can be adjusted.
[FRONT], [REAR], [SUBWOOFER]
NOTE
[SUBWOOFER] can only be selected when [ON] is selected in [SUBWOOFER] (page 29).
1
Press the M.C. dial to display the main menu.
2
Turn the M.C. dial to select [AUDIO], then press to confirm.
3
Turn the M.C. dial to select [CROSSOVER], then press to confirm.
4
Turn the M.C. dial to select the speaker unit (filter) to be adjusted, then press to
confirm.
5
Turn the M.C. dial to select [HPF] or [LPF] according to the speaker unit (filter),
then press to confirm.
6
Turn the M.C. dial to select an appropriate cut-off frequency for the speaker unit
(filter) selected in step 4, then press to confirm.
[25HZ] to [250HZ]
7
Turn the M.C. dial to select an appropriate slope for the speaker unit (filter)
selected in step 4.
[–6] to [–24] (if you choose [FRONT] or [REAR])
[–6] to [–36] (if you choose [SUBWOOFER])

Settings

You can adjust various settings in the main menu.
1
Press the M.C. dial to display the main menu.
2
Turn the M.C. dial to select one of the categories below, then press to confirm.
• FUNCTION settings (page 27)
• AUDIO settings (page 29)
• SYSTEM settings (page 31)
• ILLUMINATION settings (page 34)
• MICROPHONE settings (page 34)
- 26 -