Remember to keep your skin moisturized all the time.
Realize the massage slowly with circular movements in the area you want to
treat, without stopping the device in an area for more than five seconds
NOTE
WHEN THE ULTRASOUNDS ARE ACTIVATED IT ISN'T POSSIBLE TO START UP THE EMS
FUNCTION.
REMINDER
AVOID THE CONTACT WITH THE JOINTS OF THE BODY SUCH AS: THE AREA OF THE
KNEE; FINGERS ... ETC ALSO AVOID THE MUCOSAS; EYES OR AREAS OF THE SKIN IN
CONTACT WITH OSSEOUS AREAS
INSTRUCTIONS FOR THE USE OF THE MULTIPHOTOTHERAPY DEVICE
Once the device has been turned on (POWER), push the button (LED) and it will
switch on together with sixteen red leds in the area surrounding the magnetic
head of ultrasonic emission, that indicates that the function is working correctly.
If you push the button again the 16 LEDS of BLUE radiation will turn on
This function, together with the ultrasounds realize a metabolic action with
excellent results for your skin, rejuvenating and making it younger.
OBSERVATION
When the LED function is working, you can and must activate the Ultrasounds
function to multiply the lipolitic action.
Avoid looking directly at the HIGH EFFICIENCY LEDS, ALWAYS wear the provided
glasses.
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR THE USE OF THE DEVICE IN POSITIVE AND NEGATIVE IONIC
Push the POWER button to turn on the device.
Then push the ION+ or ION- button according to the treatment you want to
obtain.
If you push the button repeatedly it will reach levels of major intensity (L, low
intensity; M, medium intensity; H, high intensity)
OBSERVATION
When the LED function is working, you can and must activate the IONIC
function, positive and negative
1-Clean the dirt, the fat and the make up from the parts that will be massaged
with a wet towel.
2-Connect the system of electrodes: put the positive (any of the two) and
negative (any of the two) pole of the electrodes in different parts of the body
when using them, (one positive and the other negative are used simultaneously
and they are indifferent)
3-Pot the small pillows in the areas of the body where you want to obtain results.
4-Move the switch of the intensity selection (placed on the right side of the
handle) towards the first position (0).
5-Connect the cable to the device in its lower part, using the plug
6-Turn it on softly pushing the POWER button (the red light of the button will turn
on).
7-Select the massage function, on the lateral left side of the device: BASIC,
MASSAGE, CLEANSE, NOURISH, SLIM.
8-Push the EMS button, the red light on it will turn on.
9-Adjust the intensity until it's comfortable for you (from 1 to 3), on the left part
of the device.
10-The unit will stop functioning automatically after 10 minutes. If you wish to
repeat the process turn it on again and repeat it.
11-Suggestion: at first don't use it for more than 15 minutes, then increase the
application gradually until reaching 30 minutes each time.
12-Once the therapy has ended, push the EMS switch again, the device will
turn off; adjust the intensity putting it in the "0" button
13-When the Ultrasounds are working it's not possible to activate the EMS
function
FUNCTION
INTRUCTIONS TO USE EMS (GALVANIC MICROSTIMULATION:EMS)
DRAKEFOR INTERNACIONAL
15