Description Of The Appliance; Preliminary Operations; Grinding Adjustment - Eureka MIGNON ZERO Instrucciones De Montaje

EN
10

DESCRIPTION OF THE APPLIANCE

1. Container lid
2. Blow-Up Bellow
3. Coffee bean container
4. Opening / closing tab for coffee bean
container
5. Dispensing nozzle
11 LOCKING THE CONTAINER
Before starting operation, install the coffee beans container (2).
• Insert the container (2) in its seat (Fig.2) making sure the hole is aligned with the
screw on the back of the appliance.
• Screw in the locking screw (8) (Fig.3).
12 ADJUSTMENTS AND USE
12.1

PRELIMINARY OPERATIONS

Before starting work, the machine must be set up according to the type of coffee blend
(roasting level) and grinding degree.
• Select the type of coffee blend (roasting level).
• Select the grinding degree.
• Assemble the fork (7) and install it on the body of the machine (Fig.6).
• After making the electrical connection, turn the tab (4) at the base of the coffee bean
container (3) to close it (Fig.4).
• Remove the lid (1) and fill the container (3) with coffee beans.
• Put back the lid (1).
12.2

GRINDING ADJUSTMENT

Rotate the adjustment knob (9) clockwise to make the powder finer, or counter-clockwise
to increase it coarseness (Fig.5). The adjustment must be made gradually, grinding a
little coffee every 2 notches at the most. If the knob is turned by one full turn with the
motor stopped, the machine may stop.
12.3 OPERATION
• Place the container for the ground coffee (6) on the fork (7) under the dispensing
nozzle (5) (Fig.7).
• Press the side activation key (8) and after a few moments open the tab (4) allowing
the passage of coffee beans.
• After all the coffee beans have been ground, close the tab (4) and press the blow-up
bellows (2) 4-5 times to extract all the ground coffee (Fig.8).
• Complete grinding by pressing the side activation button again (8).
6. Ground coffee container
7. Container holder fork
8. Grinding activation button
9. Grinding adjustment knob
10. Coffee bean container fixing screw
27