Operation Of The Heater - HTW CON2000 Manual De Usuario E Instalacion

5. Warning：In order to avoid overheating, do not cover the heater.
6. Indoor use only.
7. Do not place the heater on carpets having a very deep pile.
8. Always ensure that the heater is placed on a firm level surface.
9. Do not place the heater close to curtain or furniture in order to avoid a fire hazard.
10. Warning：heater is not located immediately below a socket-outlet.
11. Do not insert any object through the heat outlet or air grilles of the heater.
12. Do not use the heater in areas where flammable liquids are stored or where flammable
fumes may be present.
13. Always unplug the heater when moving it from one location to another.
14. Warning：If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or a similarly qualified person in order to avoid a hazard.
15. This appliance is not intended for use by persons (including children）with reduced physical,
sensory or mental capabilities,or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance or a person responsible for
their safety.
16. Children should be supervised to ensure that they do not play with the appliance.

OPERATION OF THE HEATER

Note：It is normal when the heaters are turned on for the first time or when they are turned on
after having been used for a long period of time the heaters may emit some smell and fumes.This
will disappear when the heater has been on a short while.
Convector heater with thermostat HTW-CON2000BASIC
Choose a suitable location for the heater, taking into account the safety instructions above.
Insert the plug of the heater into a suitable socket.
Turn the thermostat knob fully in a clockwise direction to the maximum setting.
Turn on the heating elements by means of the rocker switches on the side panel. When the
heating elements are on the switches will illuminate. For maximum heat output both switches
should be on.
When the desired room temperature has been reached, the thermostat knob should be turned
2