Publicidad
Idiomas disponibles
Idiomas disponibles
Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products are carefully engineered, and factory
tested to provide long trouble-free use under normal conditions. This faucet is easy to install using basic tools and our
easy to follow illustrated instructions. If you have any questions regarding this product, contact your local distributor.
1 BEFORE PROCEEDING:
WARNING: Read all the instructions completely before
proceeding. Price Pfi ster recommends calling a professional if
you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing
and building codes.
2
2 WATER SHUT-OFF:
Locate water supply inlets and shut off the water supply valves. These
are usually found near the water meter.
3 SURFACE PREPARATION:
For optimum performance of your new Price Pfi ster Single Control
Lavatory faucet, a minimum water pressure of 20 PSI [137.89 KPascal]
is required. Have the basic tools ready for removal of old valve. If
you are replacing an existing faucet, disconnect the old one and clean
the mounting surface thoroughly.
4 TOOLS RECOMMENDED:
For Iron Pipe Installation:
♦ Phillips Screwdriver
♦ Pipe Wrench
♦ Thread Sealant
Some additional tools may be required.
5
5A
5B
Model E42-ANFC is shown.
5 INSTALLING THE FAUCET
Insert O-Ring (5B) through the Faucet Supply Tubes (5A). Insert
Faucet Supply Tubes (5A) and O-Ring (5B) through the hole in sink
(5D). Align the Faucet Body (5C) to desired position.
♦ Adjustable wrench
♦ PTFE Plumbers Tape
♦ Slotted screwdriver
5C
5D
ENGLISH
6
6 SECURRING THE FAUCET
From underneath sink, feed O-Ring (6A) and Clamp Washer (6B) over the
supply tubes (6C) and Clamp Screws (6D). Tread the Clamp Nuts (6E) on
the Clamp Screws (6D) until faucet is fi rmly secured to the sink (6F).
7
7B
7A
7
CONNECTING WATER SUPPLY LINES
Connect hot Water Supply Line (7A) to hot Inlet fi tting (7B) indicated by
red fl ag. Be sure to hold faucet inlet fi tting (7B) steady while tightening
the supply line. Wrench tighten until seal is achieved. Repeat for
cold Water Supply (7C).
2
6C
6A
6E
6F
6C
7C
6F
6D
6B
6E
6B
6E
6D
6E
6E) on
6F
6F).
Publicidad
