Descargar Imprimir esta página
GE ZX18DS Instrucciones De Instalación
GE ZX18DS Instrucciones De Instalación

GE ZX18DS Instrucciones De Instalación

Cajón de almacenamiento

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation
Instructions
2-Drawer
Storage
18-9/16"
ZX18DS
10-1/8"
18"
1-1/4" Drawer
Overlap
31-10705
11-08 JR
17-1/4"
17"
18-3/16"
24-1/8"
25-3/16"
2 Mounting
Screws
1-1/4" Drawer
Overlap
ZX18DS STORAGE DRAWER
IMPORTANT: The supplied rear support bracket
adjusts from 4-1/8 " to 6-7/8 " . When using the
supplied bracket, cut the opening at least 4-1/8 "
above the floor. If the opening is closer to the floor
of the enclosure, use another means of support for
the back of the drawer.
The rear support must be capable of supporting
50 lbs., plus load.
• Cut the opening to the dimensions shown. Reinforce
the inside of the opening using at least 1 " wide
material surround to accept the frame-mounting
screws.
NOTE: If you are installing another accessory into
the same enclosure, measure and cut the openings
to accommodate the bottom overlaps and align
them evenly across the bottom.
• Adjust the bracket height with screws (provided) so
that the drawer cabinet will be level with the cutout.
• Slide the drawers into the opening.
• Open the top drawer. Locate the screw holes in the
top of the drawer cabinet, just inside the drawer.
Install 2 screws (not provided) to secure the drawer
to the enclosure.
Side View
1
Rear Support Bracket
4-1/8" to
6-7/8"

Publicidad

loading

Resumen de contenidos para GE ZX18DS

  • Página 1 Installation ZX18DS STORAGE DRAWER Instructions IMPORTANT: The supplied rear support bracket adjusts from 4-1/8 " to 6-7/8 " . When using the supplied bracket, cut the opening at least 4-1/8 " 2-Drawer above the floor. If the opening is closer to the floor Storage 18-9/16"...
  • Página 2 Instructions TIROIRS DE RANGEMENT ZX18DS d’installation IMPORTANT : La largeur du support arrière fourni peut être réglée entre 10,5 cm (4 1/8 po) et 17,5 cm (6 7/8 po). Lorsque vous utilisez le support fourni, 2 tiroirs de pratiquez l’ouverture à au moins 10,5 cm (4 1/8 po)
  • Página 3 Instrucciones CAJÓN DE ALMACENAMIENTO ZX18DS de instalación IMPORTANTE: El soporte trasero provisto se ajusta de 4-1/8" a 6-7/8". Cuando se utiliza el soporte provisto, corte la abertura por lo menos a 4-1/8" Almacena sobre el piso. Si la abertura está más cerca del piso miento de 18-9/16"...
  • Página 4 Notes...