EN
Operation
The mirror is to be integrated in the DALI system and
can be operated by an external button A with a suitable
group controller or the button on the mirror B.
Button functions
Button Function
Light on/off
• Tap the key to turn on the light, the white LED goes
off .
• Tapping again causes the light to go off , the white
LED illuminates.
• The white LED can be deactivated.
– Switch on the mirror.
– Press and hold the button for 10 seconds.
- The lighting goes off .
- A short light impulse indicates that the white
LED was deactivated.
To switch the white LED back on, repeat the de-
scribed procedure.
Dim the light
• With the light on press and hold the key.
• When the desired brightness is reached, stop pres-
sing the key.
• Tap the key, the light toggles between minimum
and maximum level.
The setting is saved and used the next time it is
switched on.
6
Important information, please read!
Button Function
A
B
Replacement parts with order numbers, see page 27.
Setting the light colour cooler
• Press and hold the daylight white button and the
light colour will transition on all lights connected
via DALI and on DALI-controllable mirrors to cold
white.
• Release when the desired light colour has been
reached.
Adjusting light colour - daylight white (cool white)
• Touch the button and the colour temperature on all
lights connected via DALI and on DALI-controllable
mirrors will be set to 6500 kelvin.
Setting the light colour warmer
• Press and hold the warm-white button and the light
colour will transition on all lights connected via
DALI and on DALI-controllable mirrors to warm-whi-
te.
• Release when the desired light colour has been
reached.
Adjusting light colour - warm white
• Touch the button and the colour temperature on all
lights connected via DALI and on DALI-controllable
mirrors will be set to 2700 kelvin.
Heizung Ein/Aus
• Tastenfeld antippen, die rote Leuchtdiode leuchtet.
• Erneutes Antippen schaltet die Heizung aus, die
rote Leuchtdiode erlischt.
Die Heizung schaltet nach 20 Minuten automatisch
ab.
The light sources may only be replaced by the
manufacturer, its customer service or by an equally
qualifi ed person.
For information about warranty and maintenance, see
the enclosed Maintenance and Warranty Passport.
Disposal information! Equipment with this labelling
must not be disposed of in household refuse, but must
be disposed of at a collection centre intended for this
purpose.