Haier QVE110DTWW Manual De Usuario E Instrucciones De Instalación página 13

INSTALLATION
STEP 3. CONNECT ELECTRICAL
(Cont.)
WARNING
If house wiring is not 2-wire with a
ground wire, a ground must be provided by the installer.
When house wiring is aluminum, be sure to use UL
approved anti-oxidant compound and aluminum-to-
copper connectors.
Push all the wiring into the unit and install the wire cover
by pushing the edge under the tab in the housing and
secure it in place with a screw. Ensure wires are not
pinched.
STEP 4. INSTALL GRILLE
Connect the light connector from the grille to the
wire plate. Press the springs on the sides of the grille
together and insert them into the slots in the motor
assembly. Firmly push the attached grille up against the
ceiling.
49-7000175 Rev. 3
PRODUCT REPLACEMENT
In case of Haier product replacement, follow the steps
below to replace unit:
WARNING
Disconnect all electrical power at the
main circuit breaker or fuse box before installing.
1. Remove the grille from existing unit.
2. Unplug the motor and the light connectors from the
wiring plate of the current unit. Uninstall the motor
assembly by removing the screws and pulling it out of
the housing.
3. Discard the motor assembly.
4. Unbox new unit and follow step 2 of Product
Replacement section to remove motor assembly and
light grill from new unit.
5. Unbox new unit and unplug the motor connector
from the wiring plate and uninstall the motor and
control assembly by removing the three screws
highlighted in the figure below and pulling it up from
the housing.
6. Insert the new motor assembly into the existing
housing and secure using the screws as shown
Connect the motor connector to the wiring plate.
7. Connect the light connector and reinstall the grille,
turn power on to test unit.
below.
Screws
13