Instructions For Disposal - Poppstar 1010372 Manual De Instrucciones

UK
Instructions for use
1. Compare the technical information (specifications) on all products you would like to connect the transformer to and make sure
they are compatible (specifications must match or be within the specified range).
2. Read the safety instructions before installing the product!
3. Switch off the fuse and check with a voltage tester whether the wires to be connected are completely voltage-free.
4. Leave about 50 mm space around the transformer in all directions when installing.
5. Connect the secondary circuit (output) first after removing the cover cap (not necessary for product 1010372).
6. On the secondary side, the two terminal blocks with marked polarity are now exposed.
7. Connect your LEDs in the correct polarity to the terminal blocks in the secondary circuit.
To calculate the total power (P in watts) of your LEDs, multiply the current consumption of the LEDs (I in amperes) by its voltage
(U in volts). Formula P=U*I applies here. In parallel circuits, the voltage (U) remains constant.
8. When all devices on the secondary side are correctly wired, connect the primary side (input) to the mains via the terminal blocks
N and L.
9. Replace the cover caps and screw them on tightly (not necessary for product 1010372).
10. Secure the product with the 2 mounting slots on a dry and firm surface.
11. Switch the fuse back on.
The voltage transformer works as soon as there is voltage on the primary side. It does not have its own on/off switch and is
maintenance-free.
Liability
Poppstar GmbH is not liable for personal injury or property damage caused by incorrect installation, use or maintenance.

Instructions for disposal

Product:
According to the European WEEE Directive, electrical and electronic equipment must not be disposed of
with regular household waste. Their components must be recycled or disposed of separately because toxic
and hazardous components can cause permanent damage to health and to the environment if disposed
incorrectly.
As a consumer, you are obliged under the Electrical and Electronic Equipment Act (ElektroG) to return elec-
trical and electronic equipment free of charge at the end of its service life to the manufacturer, the outlet
or the public collection points set up for this purpose. Details are regulated by the applicable national law.
The symbol on the product, the instructions for use and/or the packaging indicates these regulations. By
separating, recycling and disposing of old appliances in this way, you are making an important contribu-
tion to protecting our environment.
Packaging:
Packaging can be disposed of free of charge at the appropriate collection points: paper in the paper bin,
plastics in the plastic bin and glass in the correct glass container.
EC Declaration of Conformity
By means of the CE symbol, Poppstar GmbH declares that the product complies with the basic require-
ments and directives of the European regulations.