Seat Post Installation; Pedals Installation - JUPITERBIKE ATLAS Manual De Instrucciones

SEAT POST INSTALLATION

PEDALS INSTALLATION

Unlatch and loosen seat
clamp. Put seat post in
frame and adjust to desired
height. Retighten and re-
latch clamp.
The right pedal is reverse
threaded so twist in the
opposite direction. Look
for an R engraved on the
threaded end. It should
hand twist easily on the
pedal arm. If it doesn't,
unscrew and try again.
Use a 15mm wrench for
the last 1 or 2 turns. Repeat
with the left pedal on the
other side.
7