Mounting; Mobile Stand Set-Up - Welch Allyn LS200 Manual Del Propietário

MOUNTING

MOBILE STAND SET-UP

1. Remove stand base, pole and hardware kit from boxes.
2. Place stand base on floor with casters down
and lock casters.
3. Insert pole end (A) into hole in base of
mobile stand.
4. Rotate pole until it aligns with pin and drops
into place.
5. Insert cap-head bolt (F) with lock washer (f)
through stand cross member into pole
and tighten with 1/4" Allen wrench.
6. Carefully remove LS200 arm/luminaire
assembly from box. Hook transformer
onto the factory installed mounting screws
(C) on the pole and slide down until secure.
7. Place arm/luminaire assembly on pole by
sliding universal connector (B) onto top
end of the pole and align screw holes.
8. Insert 0.5" (13mm) flathead screw (b) into
hole on side of universal connector and
tighten with 5/32" Allen wrench.
9. Push power cord attached to transformer
into power cord clips (D) on pole,
ensuring enough slack for full range
of arm motion.
10. Attach power cord (e) to transformer.
11. To lock casters, push down on the tab
on the locking casters.
12. Before moving the LS200 Procedure Light,
refer to "Transport Instructions"
on Page 8.
ALIGN PIN IN
MOBILE STAND
WITH POLE END
(b)
(D)
(A)
CASTER
LOCKS
4
(B)
(e)
(C)
(f)
(F)