EN - USER MANUAL
V Thanks for choosing the Steelplay® Dual Charging Stand.To ensure the safe use of the product, please read
carefully the instruction manual before using it and keep the manual for any future reference.
V WARNING - FOR YOUR SAFETY WHEN USING THIS PRODUCT, WE RECOMMEND THAT YOU READ THIS MANUAL
AND RETAIN THESE DOCUMENTS FOR FUTURE REFERENCE CAREFULLY.
SAFETY INSTRUCTIONS
1. SAFETY OF CHILDREN AND VULNERABLE PEOPLE
V AVERTISSEMENT :Risque de suffocation
Make sure to never leave this product within the reach of young children. Do not let children play with the device. Do
not leave packaging within the reach of children. Children should not clean or attempt any maintenance on the device
unattended.
2. GENERAL SECURITY
V WARNING: Risk of injury, electric shock, fire, burns or damage to the device
V WARNING: Do not attempt repairs
V WARNING: Do not allow your accessory to become wet
Do not use the product with wet hands and avoid any kind of moisture. Do not move the product when it is powered.
Do not drop, do not disassemble, do not open, do not crash, do not bend, do not deform the product or any of its
parts, this could seriously damage them. Do not use water to clean the product or any other cleaning agent. Do not
use abrasive cleaners, scouring pads, solvents or metal objects. To clean the product, use an anti-static cloth. To avoid
electric shock, do not disassemble the product yourself. All repairs must be performed by qualified personnel. Prevent
any liquid from entering the product. Do not insert any object other than those permitted in the product as they may
touch dangerous voltage points or cause a short circuit resulting in a fire or electric shock. Do not place heavy objects
on the product. Avoid excessive shock or vibration of the unit. This unit is intended for indoor use only. The unit must
not be exposed to water dripping or splashing. Do not place objects filled with liquids such as vases on the device.
Do not change the specifications of this device. If the power cable is damaged, it must be replaced by the
manufacturer, its service agent or a qualified technician to avoid a hazard. Before any maintenance, switch off and
unplug the AC power supply. Do not spray water or steam to clean the unit. Be careful not to hurt your hands or
fingers on the sharp corners. Check that the mains voltage corresponds to the voltage indicated on the label on the
back of the product or in the user manual. The lack of light does not mean that the product is completely disconnected
from the power supply. To disconnect the device, remove the cable. The humidity of the room where the product is
installed must not exceed 90%. The transfer of the product from a cold to a warm place may cause condensation on
some components. Let the condensation evaporate before turning on the device.
3. INSTALLATION
Do not install and do not connect a damaged device. Carefully follow the installation instructions provided with the
device. Do not install or do not use it in a place where the temperature is below 15 ° C or in a place exposed to the
elements. Do not place the product in direct sunlight or near a source of heat. Install the product in a dry place and
protected from dust. Do not place in areas subject to splashing water. Do not place the device flame sources such as
lighted candles. Before installing the device, make sure the surface will bear his weight. Do not place this product on
an unstable surface. Do not install the product on shelves or on a sloping surface. Also avoid locations subject to
vibration or not to support the product properly. Otherwise, the product may fall, which can lead to injury or damage
the product.
4. ELECTRICAL CONNECTION
V WARNING : Cable and cord. Place all cables and cords so that nobody (or pet) can be caught in the feet or shot
by mistake by moving in the room. Keep cables and cords out of reach of children and pets. Do not let children play
with cables and cords. If you do not plan to use this product for a long time, turn it off by disconnecting the power
plug. During thunderstorms, we recommend disconnecting the product so that it is not damaged by possible electrical
or electromagnetic surges. For this reason, the outlet should be easily accessible, so as to disconnect when needed.
Unplug the device immediately if you notice it exudes a burnt or smoke. Do not under any circumstances open the
product yourself, you might receive an electric shock. Do not touch the power plug with wet hands. Also, if the plug is
wet or covered with dust, dry or completely wipe the power cord. Excessive moisture can cause electric shock. Be sure
to connect the power cable to a grounded outlet. (Does not apply to devices that do not require grounding.) If it does
not, you may be electrocuted or injured. Attach the power cord. If the power cable is not attached properly, a fire
may occur. Make sure the power cord is not in contact with hot objects like a heater. Failure to do so may cause fire
or electric shock. Do not place heavy objects or the product itself, on the power cord. Do not plug too many devices
on one wall strip. Do not insert a conductor wire as a metal rod in one end of the power cable if the other end is