Publicidad
TxConfig USB Interface
Quick Guide
TxConfig USB is a configuration interface for NOVUS family of
transmitters and can supply transmitters with 0-10 Vdc or 4-20 mA
outputs. It is used with the TxConfig configuration software.
FEATURES
Easy installation.
•
USB communication with the PC and serial communication with the
•
transmitters.
Powers the transmitters without requiring a battery or external
•
power supply.
Easy electrical connections.
•
Compatible with USB 1.1 and 2.0.
•
Cable length: 1 m.
•
Operating system: Windows.
•
ELECTRICAL INSTALLATION
Connect the device according to one of the connections beside.
•
Connect the TxConfig USB interface to the PC.
•
TxConfig USB will be installed automatically.
•
To configure a device, run the TxConfig software.
•
OPERATION
Follow the instructions in the TxConfig software.
STATUS LED
LED on: The interface was installed and is ready for use.
•
LED blinking: The device is communicating with the transmitter.
•
Warning: When performing the configuration with the
transmitter connected to the process, do not connect
the black and red wires to the transmitter, as this
may permanently damage the interface.
Connect only the white and green wires, as shown in
the figures.
ELECTRICAL CONNECTIONS
TxBlock / TxIsoBlock Transmitter
1.
English
RHT / Temp Transmitter
2.
TxRail Transmitter
3.
TxIsoRail Transmitter
4.
T x C o n f i g U S B
I n t e r f a c e
Q U I C K
G U I D E
WARRANTY
Warranty
conditions
are
available
www.novusautomation.com/warranty.
on
our
website
QG 5010046 V1.0x E
Publicidad
