Uline H-9637 Manual Del Usuario página 7

TABLETOP POWER STRIP ASSEMBLY
1. Choose desired location for power strip. Place two
supplied mounting clips roughly 32" apart (clip side
up). Using an electric drill, fasten to tabletop with
two supplied wood screws. (See Figure 21)
Figure 21
2. Secure power strip (13) by snapping into the
mounting clips. (See Figure 22)
Figure 22
MONITOR ARM ASSEMBLY
1. Line up monitor arm (14) mounting bracket with
uprights at desired height.
2. Secure monitor arm mounting bracket to uprights with
two M6 x 35 mm or M6 x 50 mm Allen head bolts, two
small flat washers and two hex nuts using an
Allen wrench and 10 mm wrench. (See Figure 23)
Figure 23
Hex Nut
Small Flat
Washers
PAGE 7 OF 24
OPTIONAL ACCESSORIES CONTINUED
Allen Head Bolts
ATTACHING MONITOR
NOTE: Make sure monitor has a VESA hole pattern
of 100 x 100 mm or 75 x 75 mm. (See Figure 24)
NOTE: If monitor is attached to a fixed base,
remove monitor from base.
CAUTION! Be careful not to scratch screen
during installation.
Figure 24
75 x 75 mm or
100 x 100 mm
1. Easy-adjust monitor mount includes a built-in
counterweight system for free-range motion. Arm in
mount may need to be adjusted to allow monitor to
stop at desired position. Attach monitor to plate.
(See Figure 25)
Figure 25
Allen
Wrench
Use appropriate bolts for monitor.
2. To adjust the counterweight, use 5 x 5 Allen wrench
on screw above middle joint. Turn toward "–" if
monitor raises up. Turn toward "+" if monitor lowers.
Adjust until mount can be stopped at desired
position. (See Figure 26)
Figure 26
±180º -85º ~15º
Adjust swivel
with Allen
Wrench
Large Flat
Washer
Adjust Tilt with
Allen Wrench
±90º
±180º
0322 IH-9637