Fence Assembly; Safety Guard - KNOVA KN S-38W2 Manual Del Usuario

SEP UP
Fig. 12 Masking tape location for lowering wing.

FENCE ASSEMBLy

To install the fence assembly:
1. KEEP SHAPER DISCONNECTED FROM POWER!
2. Remove the cap screws with hex wrench as shown in
figure 14.
Fig. 14 Remove the cap screws.

SAFETy gUARD

W A R N I N G
All guards MUST be installed on your
shaper before operating it. Shapers are
dangerous machines that can quickly
cause serious injury if some kind of guard
is not used. To protect yourself, read and
follow the entire instruction manual
carefully and do additional research on
shop made guards and safety jigs.
There are other methods to protect yourself, in addition to the
safety guard. However, some type of safety guard must be used
at all times.
To assemble the safety guard:
1. Attach the shaft mount bracket (See Figure 16) to the back of
the table with the hex bolts and lock washers already mounted
to the table.
Fig. 13 Masking tape location for raising wing.
10. Following adjustments, tighten the hex bolts in the sequence
they were installed.
3. Replace the cap screws with fence lock levers
Fig. 15 Replace the fence lock levers.
2. Insert the shaft
(Figure 16) into the
bracket so the flat
surface faces away from
the machine.
3. Slide the extension bracket
(Figure 16) through the
shaft and secure it with
the lock knob.
4. Using the two 5/16" -18 x
3/4" flat head screws and
hex nuts, tightly secure the
extension bar to the main
guard. See Figure 16.
5. Attach the guard assembly
to the shaft assembly and
tighten the lock handle.
5
Extension bar
Main guard
Extension bracket
Shaft
Hex bolt &
lock washer
Shaft mount bracket
Fig 16. Guard assembly
Lock
handle
Lock knob
Set
screw