Trimming Adjustments And Control Test; Installing The Battery; Trimming Check; Switching Off - Merlin POLARIS 400CP Manual De Instrucciones

Ocultar thumbs Ver también para POLARIS 400CP:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Trimming Adjustments and Control Tests

Installing the battery

To install the Li-PO battery
into the fuselage insert the
charged battery into the
bottom of the helicopter
base.

Trimming Check

1.
Switch on your transmitter and make sure the throttle stick is fully pulled back.
2.
Make sure the battery is plugged in. Leave the helicopter until you see the power light stop flashing and
remain constant to confirm the unit has calibrated.
3.
The helicopter swash plate should be horizontal
when viewed from the front and from the side of
the helicopter. If it is not, adjust it's position by
operating the cyclic trims on the transmitter.
4.
Move the cyclic control stick to the left and the
swash plate will tilt in the indicated direction in
the picture.
5.
Move the cyclic control stick forwards and the
swash plate will tilt as indicated in the picture.

Switching Off

Unplug the helicopter battery followed by switching off the transmitter. Always follow this procedure when switching
off.
6
All manuals and user guides at all-guides.com

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido