Inspection, Maintenance And Repair; Storage And Disposal; Warranty - Lumatek VF650W Manual

7. INSPECTION, MAINTENANCE AND REPAIR

Warning! Disconnect the LED diver from mains before performing any maintenance or repairs.
Warning! Do not connect or disconnect the LED fixture under load.
Warning! Do not open or disassemble the LED driver, it contains no serviceable parts inside. Opening the LED
driver can be dangerous and will void the warranty.
Warning! Always wait 20 – 30 minutes for the LED light bars to cool down before handling.
Caution! Do not clean the LED fixture with detergents, abrasives or other aggressive substances.
Regularly check the LED driver for dust or dirt build up. Clean if necessary. Contamination may cause
overheating and decreased performance.
Clean the outside of the LED driver using a dry or damp cloth.
Regularly check the cables of the LED driver to ensure it is undamaged.
The LED driver features surge protection for safe operation and device protection. In the event of over or
under mains voltage fluctuations, open or short circuit and over safe driver temperature; the LED driver will
switch off automatically. The driver will operate again when the surge protection parameter values are within
safe use range again.
To reset the LED driver; switch off mains power supply and then switch on mains power supply.

8. STORAGE AND DISPOSAL

Store the LED driver in a dry and clean environment, with an ambient temperature of -25ºC to 55ºC.
The product must not be discarded as unsorted municipal waste but must be collected separately for the
purpose of treatment, recovery and environmentally sound disposal.

9. WARRANTY

Lumatek warrants the mechanical and electronic components of their product to be free of defects in materi-
al and workmanship if used under normal operating conditions for a period of five (5) years from the original
date of purchase. If the product shows any defects within this period and that defect is not due to user error or
improper use Lumatek shall, at its discretion, either replace or repair the product using suitable new or recondi-
tioned products or parts. In case Lumatek decides to replace the entire product, this limited warranty shall
apply to the replacement product for the remaining initial warranty period, i.e. five (5) years from the date of
purchase of the original product. For service; return the product to your shop with the original sales receipt.
info@lumatek-lighting.com
www.lumatek-lighting.com