Preparing For Use; Charging Your Rotadent Procare; Assembling Your Rotadent Procare - DenMat Rotadent ProCare 94000N Instrucciones De Uso

Preparing for Use

Charging Your Rotadent ProCare

The Rotadent ProCare is powered by a rechargeable nickel-metal hydride (NiMH) battery. When
fully charged, the Rotadent ProCare may last up to two weeks (when used for two minutes, twice a
day), depending on brushing conditions.
Initial Charging
• Plug the power cord of the charging base into a working outlet.
• Place the Rotadent ProCare into the charging base. The charging indicators will blink.
IMPORTANT: In order to achieve a full charge, charge your Rotadent ProCare for at least
24 hours prior to initial use.
Recharging
When the power level of your Rotadent ProCare noticeably decreases, it is time to recharge the
battery. Follow the steps listed under the Initial Charging section.
Once the battery has reached a full charge, the LED indicators will stop blinking (as shown in the
LED Indicators section on the next page). At that point, there is no risk of overcharging the battery
by leaving the handle on the charging base. For everyday use, you can safely leave the handle on
the charging base with the charging base plugged into a wall outlet, without affecting the useful life
of the battery.
IMPORTANT: The handle is sealed for your safety and the battery is not accessible.

Assembling Your Rotadent ProCare

Color Ring Attachment
• Orient the color ring so that the taper matches the taper of the neck.
• The color ring will be oriented on the neck so that the internal detail matches the external detail
on the lower portion of the neck.
• Attach the color ring by hooking one edge on the bottom of the brush head and stretching it
into place.
• The color ring can alternately be attached by sliding it over the top of the brush head and down
the neck, into position.
Brush Head Attachment
• Align the brush head so that the MicroFilaments
(the same direction as the on/off button).
• The inner components of the brush head should align easily with the brush head connection at
the top of the handle.
• Push the brush head down onto the handle until it locks into position. You should hear a very soft
"click" sound, confirming that the brush head is securely in place.
English
All manuals and user guides at all-guides.com
®
are facing outward from the front of the handle
™
6