ledscom LC-EL-058-WW Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
Drill a 35mm diameter and 55mm deep
mounting hole (4) to properly install the
fixture.
Guide the connecting cable (3) through the
installation opening (4), press the side clips
(2) against the light and place the light (1)
in the installation opening (4).
4. Connect the connection cable if
necessary. with an extension cable or
directly with a transformer that has the
appropriate plug-in system (Figure 2).
Screw the cap tightly to protect the
connection from water. Make sure that the
screw cap is not in the water.
5. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English Ground recessed light (LC-EL-058-WW) - Assembly instructions
Figure 1
1: Luminaire
2: Brackets
Figure 2
3: Connection line
4: Installation opening
04/2022