Honeywell HCC484TP Guia Del Usuario página 12

Figure 3
Pin DC (Direct Drive) lens
1 CTRL -
2 CTRL +
3 DRV +
4 DRV -
3. Set the EE MODE to ALC MODE on the OSD menu (see
ALC Mode on page
Auto iris lens with amplifier: Set the VSD LENS on the OSD
menu.
Auto iris lens with no amplifier: Set the DC LENS on the OSD
menu. Adjust to the LEVEL carefully to avoid hunting.
4. Set the switch on the rear of the camera to DC or VSD.
UP
MENU
-
DOW N
Auto iris lens: Use the connection recommended by the
manufacturer. For best practices, read the lens manual
carefully. You may need to set the flange back focus.
Rev 1.01
Auto Iris Lens Pin Definition
13).
VIDEO
CONT
+
CV
VSD
DC
4
4-pin lens terminal
Video (VSD) lens
Power (+12V)
NC
Video Signal
GND
Video Output Selection Switch:
Set to CV for Composite Video.
Set to TP for UTP Video.
Set to VSD for an auto iris lens with a built-
in amplifier (video-type lens).
Set to DC for an auto iris lens without an
amplifier (DC-type lens).
2 1
4 3
ELC /
900.0512
07/06