Operating; Filling Hydraulic Oil - probst PW-III Instrucciones De Uso

Adjustments and operating
4.2

Operating


For a slowly lowering of the forks (3) activate the lever II at the hydraulic cylinder anti-clockwise .

As soon as the forks (3) are lowered adequate, the PW III can be positioned under the pallet.

To raise the load (pallet) move the elevating lever I from position 1 to position 2 and the back again until
the required height is reached (maximum height 200 mm).
Regard, that this action only occur lever II should be in position 1 for it to work correctly.

Transport the device (PW III) with the pallet to the place of destination and lower the pallet slowly, by
opening (anti clockwise) the hydraulic lever II.
When lowering the load pay attention. Danger of squeezing the feet!
Therefore, always keep distance. In particular, children are at risk.
The device (PW III) is equipped with no parking brake.
For this reason it is absolutely necessary that the device is fixed with sloping location additionally with brake
blocks.

Lower the device (PW III) Regard, when it is not in operation - to raise the life time of the hydraulic.
4.2.1

Filling Hydraulic Oil

If the oil cylinder needs to be topped up, the following steps should be followed:

Lower the forks (37Fig.1) of the Pallet Truck by turning the lever II anti-clockwise.

Loosen the Allen M8 screw situated on the cylinder (see Fig.2) and top up the oil through the hole until it
overflows.
5110.0011
Fig. 2
V2
9 / 12
GB