Bluetooth Pairing; Indicator Lights; Troubleshooting Guide - Party Light & Sound KAMIC-STAR Manual De Uso

EN

BLUETOOTH PAIRING

Keep button (4) pressed for 3 seconds to switch the unit on. The RGB LEDs light up. The unit is in pairing mode.
Start the Bluetooth search on your mobile phone and select KAMIC-STAR in the list of found devices. You will
hear a voice prompt: "BT is connected" when pairing was successful. .You can now play and/or singl along with
your songs on your mobile phone.
Please note: Pairing is only required at the first use. Afterwards, the unit will reconnect automatically to the lat-
est device or it will connect to the nearest paired device (Apple & Android systems work also like that).
KARAOKE USE (reference software: WeSing)
Android System:
Turn on the mic and pair it with your smartphone. After pairing, you can directly use the supplied audio lead.
Then open the WeSing software, click on the handheld mic icon to choose the singer, rating, chorus and a song
for karaoke. Please note! You must be connected to the internet!
When the songs have been loaded 100%, you can start singing them.
Note: Stay close enough to your smartphone if you are using the Bluetooth function otherwise the connection
may be unstable.
iOS:
Turn on the mic and pair it with your smartphone. After pairing, you can directly use the supplied audio lead.
Then open the WeSing software, click on the handheld mic icon to choose the singer, rating, chorus and a song
for karaoke. Please note! You must be connected to the internet! When the songs have been loaded to 100%,
turn off the speaker icon (headphone function), otherwise you may hear noise. When the headphone listening
function is turned off, you can start singing.
TF card mode
When the mic is on and you insert a microSD card, it will automatically switch to the card. The songs will auto-
matically start playing after 2 seconds. Files must be in MP3 / WAV format. During play, the LEDs light up in a
breathing effect. The maximum capacity of the microSD card is 32GB.
Headphone mode
Pair the microphone with your smartphone. Connect the headset audio cord to the microphone. This will auto-
matically mute the speaker and the sound will be sent to the headphones. When you unplug the audio lead, the
sound will automatically come out of the speaker again.
Record function
Turn on the microphone. Connect the recording lead to your smartphone. Use the Karaoke software to record
your voice.

Indicator lights

ON: All RGB LEDs are on
OFF: All RGB LEDs ar off
Play music: The RGB LEDs light up to the ryhtm of the music
During battery charge: The LEDs light up in red during charge and goes off when charge is completed.
Trouble-shooting guide
• The device does not turn on.
Charge the device for more than an hour before first use.
• The device is not charging.
1. Replace the cable and try again
2. Check that the cable is properly connected.
• You can't hear your own voice.
1. The microphone is muted. Increase the volume.
2. Check if the headphones are plugged into the headphones plug.
• No sound during playback.
1. Check if the connection type is correct.
2. Check the volume setting of the smartphone
3. Check the connection on the plug
• The recording does not work or the sound is weak
1. Make sure the connection type is correct.
2. Check the connection on the plug.
3