Sensica Mini 300 Manual De Instrucciones página 10

to decrease or increase
the energy level according
to your comfort level,
as determined by the
preliminary test. Each press
will change the energy,
from the lower level to
the higher, for a total of 3
different energy levels.
4. The energy level display
indicators will light up green
according to the selected
energy level (e.g., at energy
level 1, one green light will
be lit, at energy level 2, two
green lights will be lit, etc.).
5. Place the treatment
window on the desired
treatment area, ensuring
full contact with the skin
and press the trigger
button (marked as
to release a flash.
6. Following each flash, move
the device to the next spot.
After each flash, the device
will take 1-3 seconds to be
ready for the next flash.
The safety sensor will
not trigger a flash if:
• The device is not
properly applied to the
skin. In this case, the
status indicator will turn
"momentarily" orange.
10
• Your skin tone is too
dark/tanned. In this
case, the status
indicator will turn
"momentarily" red.
7. After the treatment, turn
off the device by pressing
the ON/OFF button.
Unplug the unit after
each treatment session.
Standby Mode
When the unit is left inactive
for more than 3 minutes the
device will revert to STANDBY
mode. This is indicated
by a Blinking Green light.
Press the ON/OFF button to
return to treatment mode.
Stamp or Gliding Mode
There are two recommended
methods for treatment:
)
Stamp or Glide.
For stamp mode place the
device on the skin, press and
release a flash. This treatment
is most recommended for
small areas such as face,
bikini line and underarm.