EAS ELECTRIC EASManager Manual De Instrucciones página 20

Mounting on wall:
Mark 2 drill holes on the wall and align them horizontally. Distance

between the center of marks should be 72mm. Drill the holes using a
6mm bit to 30mm depth.
Insert the expansion bolts into the drill holes. Insert the ST4.2 screws

into the expansion bolts. Leave the screw heads protruded from the
wall surface for 4mm.
Align the mounting holes on the product to the protruded screws.

Hang the product onto the mounting screws. Ensure the product is
stably attached.
Mounting on DIN Rail
Mark 2 drill holes using the DIN rail as a template. Distance between

the center of marks should be 186mm. Drill the holes using a 6mm bit
to 30mm depth.
Insert the expansion bolts into the drill holes.

Install the guide rail onto the EASMANAGER with M3*6 countersunk

head screws
6 V.1