Publicidad
Idiomas disponibles
Idiomas disponibles
TF 0124/0134/0144
1. DESCRIPTION
1. Fan blade
2. Axis
3. Closing of the grille
4. Base
5. Rear grille
6. Oscillation button
7. Engine housing
8. Support tilt
9. Axis tilt
10. Body
11. Front grille
12. Nut blade
13. Speed control
14. LED indicator
2. ASSEMBLY
- Please, check that the fan is unplugged and speed control to position 0.
- Insert the rear grille to the axis motor, place the supplied nut to secure the rear grille.
- Place the blade on the axis and place the corresponding nut. Check manually that the blade rotates
correctly. For TF 0124 place the blade on the shaft and push until it clicks.
- Place the front grille and install the plastic ring around the grids. Tighten the screw of the grid to set the
ring.
- In the TF 0124, oscillation button must be mounted with the supplied screw, screw it into place.
3. OPERATION
- Place the fan in the desired location. Check that the speed control is set to 0. Connect the fan to the
power supply.
- Select in the speed control, the desired speed ( 0 – off; 1 – low; 2 – medium; 3 – high). TF 0124 only has
two speed. When the fan is running the LED will light.
8
Publicidad
