Cleaning And Maintenance - Royal Catering RCSM-850-550 Manual De Instrucciones

3.4. Cleaning and maintenance

a) Before cleaning, adjustment or replacement of accessories, and when the
device is not in use, pull the power supply plug and let the device cool down
completely.
Wait until the spinning elements stop.
•
b) Use only non-corrosive agents for cleaning the surface.
c) Only mild cleaning agents designed for cleaning surfaces which come into
contact with food may be used to clean the device.
d) After each cleaning, all components should be well dried before the device s
used again.
e) Store the device in a dry and cool place protected from moisture and direct
sunlight.
f) Do not spray the device with a stream of water and do not immerse it in water.
g) Ensure that no water enters through the ventilation openings in the housing.
h) Clean the ventilation openings with a brush and compressed air.
i) Regularly inspect the device for technical failure and damage.
j) Use a soft, damp cloth to clean the body of the device.
k) After using the appliance for hot food, cool it in cold water before removing
the whisk or blender attachment to prevent scalding.
l) Cleaning the blending attachment: place the blending attachment in a
container of water and switch on the appliance for a few seconds. Thoroughly
dry the blender/whisk attachment after each use.
DISPOSAL OF USED DEVICES
At the end of its service life, this product must not be disposed of with normal
household waste, but should be taken to a collection point for the recycling of
electrical and electronic devices. This is shown by the symbol placed on the
product, operating manual or the packaging. The materials used in the device can
be reused according to their intended use. By reusing materials or conducting
other forms of using used devices, you make a significant contribution to the
protection of our environment.
Local administration will provide you with information about the
appropriate point for disposal of used devices
.