Rear Panel; Configuration Mode; Power Switch - Denon Professional DN-V750 Instrucciones De Operación

(2) Rear panel

q
q PARALLEL REMOTE terminal
This is the terminal for parallel control from an external device.
w SERIAL REMOTE terminal
This is the terminal for serial control from an external device.
Use a serial straight through cable for connection to a
computer.
e ETHERNET terminal
This is a 10 Base-T/100 Base-TX LAN connector.
Use it to connect the DN-V750/V755 to a computer or hub
using an enhanced category 5 compatible LAN cable.
r MODE selector switches
Use these to switch the DN-V750/V755's operating mode.
Switch
No. Setting
OFF/OFF
OFF/ON
2/1
ON/OFF
ON/ON
OFF
3
ON
OFF
4*
ON
Sets the bit rate for serial control.
w
Mode
Native mode
LD compatible mode

Configuration mode

Reserved mode
OSD on
OSD off
9,600 bps
Native mode : 38,400 bps
LD compatible mode : 4,800 bps
e r t
y
t COMPOSITE VIDEO OUTPUT terminal (RCA)
This is a composite video output termnal. Connect it to a video
monitor equipped with a composite video input using a 75Ω
RCA cable. The connected device must be terminated at 75Ω.
y S-VIDEO OUTPUT terminal
This is an S-Video output terminal. Connect it to a video
monitor equipped with an S-Video terminal using an S-Video
cable.
u ANALOG AUDIO OUTPUT terminals
These are analog audio output terminals. Connect them to an
amplifier with analog audio inputs, speakers with built-in
amplifiers, etc., using RCA pin-plug cables.
i POWER switch
Set this to the ON side to turn the set's power on.
o DC-INPUT terminal
This is the power input terminal. Connect the included AC
adapter here.
u i o
ENGLISH
11