Storage Recommendations; Intended Use; Installing And Removing The Battery Pack - DeWalt DCV580H Manual De Instrucciones

Storage Recommendations

1. The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE

Intended Use

The vacuum is designed to operate on a D
Max* Li-Ion battery pack. The battery pack and charger are
sold separately.
The vacuum is designed to perform as a wet/dry unit
with no component changes required when changing
from wet to dry, or dry to wet pick up. This vacuum is for
household use.
It is recommended that the tank be emptied of any dry
contents prior to being used for wet pick up to facilitate
tank cleaning.
This product is NOT to be used for filtering of pathogens,
for example Covid-19. Follow all local, state, and federal
guidance on general cleaning practices.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. C)
nOTE: Make sure your battery pack is fully charged.
To install the battery pack into the vaccum, slide battery
pack into battery port 1 . Make sure the battery pack is
fully seated.
Fig. C
1
To remove the battery pack from the vacuum, press and
hold the battery release on the battery pack and remove. To
charge the pack, insert it into your D
Using the Appliance (Fig. A, D)
1. Attach the appropriate accessory to the hose
2. Insert the D
3. To turn machine on, press the I/O (on/off) button
WALT 20V
Vacuum Cleaning
e
To Empty Tank (Fig. E)
The sound of the motor changes and suction is reduced
when the tank is full.
1. Turn machine off and remove the battery pack.
2. Unlatch the tank latches
3. Empty the contents of the tank into a suitable container.
4. Clean or change filters
5. Inspect machine for damage by foreign objects. Contact
6. Replace power head onto the tank and latch securely.
nOTE: The machine must be used in the upright position
at all times to prevent unwanted actuation of the Automatic
Vacuum Shutoff. If unwanted actuation should happen, turn
off the motor and wait until the motor stops turning. Turn
the motor on again and suction will be restored.
Filter
Filter Care (Fig. F)
The wet/dry filter
life filter. To be effective in minimizing dust recirculation the
filters MUST be installed correctly and in good condition.
nOTE: Never operate without a filter in place. A clean filter is
the most important factor in the operation and efficiency of
WALT battery pack.
e
Fig. D
4
from the tank.
5
this manual.
Fig. E
the nearest D WALT authorized service center for
e
replacement of damaged or missing parts.
5 included with this vacuum is a long
English
WALT charger.
e
.
2
3
and remove the power head
. See Filter section of
5
4
.
7