Atlantic ECOBLOX Manual Del Producto página 4

5. Install the top panel 74269 by inserting the slide lock tabs of all four small panels into the
receiving channels and slide until the panel is snug.
6. To complete the assembly, flip the Eco-Blox on its side and push down where the panels
meet until all edges are aligned.
7. IMPORTANT! Rotate the Eco-Blox so that the bottom panel is flat on the ground and the
top panel is facing up. In this position, the top panel is supported by the sides as well
as the center support panels. Eco-Blox must always be installed in this position.
Improper installation, with the edges of the support panels visible on top, will reduce the
structural integrity of the unit and may cause the Eco-Blox to fail.
Building Multiple Eco-Blox Modules
Start with an assembled Eco-Blox. The top panel
replaces the bottom panel from Step 1.
Begin by installing the 4 small panels from Step 2
onto the finished Eco-Blox and continue through
Step 7. Repeat for taller Eco-Blox modules.
Installation
Eco-Blox water matrix reservoirs are a strong,
versatile way to store water underground,
but a few guidelines must be followed for
proper performance and longevity.
EcoBlox must be oriented with the top panel
covering the edges of all vertical panels. Setting
the Eco-Blox on its end or side, with exposed edges
on top, will allow the panels to
decouple under load and potentially, collapse.
4
CORRECT
ORIENTATION
INCORRECT
ORIENTATION