jbc MS 9024 Manual Del Usuario página 3

We appreciate the trust you have placed in JBC by purchasing this equipment. It
has been manufactured with the strictest quality standards in order to give you the
best possible service.
Before using this equipment, we recommend you read these instructions carefully.
Electric desoldering pump
MS 9024 Ref.9024000
Desoldering air filter
The MS 9024 is a suction pump that includes a
vacuum pump that only needs to be connected
to the control unit.
You can connect the following stations from the
JBC range: DI2860, DD5700, DM6700, MD2960.
Aspiration
inlet
Connection
Technical specifications
- Supply: 24V.
- Power: 10W.
- Weight of complete unit: 1,6 Kgs.
- ESD protected housing.
Typical surface resistance: 10
square.
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
antistatic protection.
- RoHS compliant.
This product should not be thrown in the
garbage.
Changing the pump inlet filter
Verify the filter at the entrance of the pump,
and change it if dirty or obstructed, therefor:
- Disconnect the desoldering iron tube and
unscrew the stopper.
- Take out the 2 paper filters and throw
away those which are soiled.
- First place the new filters in the top and
afterwards the toric joint. Always use 2 filters.
- Screw on the stopper and connect up the
tube.
- Check the airtightness.
Toric joint Ref.0007717
Spare filters Ref.0005966
JBC reserves the right to make technical changes without prior
notification.
2
ENGLISH
5 -10 11 Ohms/