FONESTAR ZS-11 Manual De Usuario página 4

EN
CONNECTION
Make the connections with the amplifier and all the components of the audio system switched off and
disconnected from the power supply.
For the connection of the microphone to the zone system mod. ZSC-1110 a Cat 5e type cable is used. This
cable is connected to one of the sockets COM of the zone system mod. ZSC-1110 and to one of the sockets
COM of the first microphone ZS-11.
In the event of having more than one microphone, connect them to each other connecting the COM connector
of the first to the COM connector of the second.
Once the connections have been made according to your needs, connect the devices to the power supply
and switch them on. After use, do not forget to switch them off and disconnect them from the power supply.
CONTROL CABLE
The connection between the microphone and the PA system or several microphones in cascade must be
made using a Cat 5e or Cat 6 cable. This cable consists of 8 conductors which must be connected according
to the diagram above and finished at both ends with RJ-45 (8P8C) connectors.
For example, the following colour code can be used:
1 – Blue
2 – Blue/White
3 – Brown
4 – Brown/White
5 – Orange
6 – Orange/White
7 – Green
8 – Green/White
The numbering of the different cables is shown on the front of the RJ-45 connector.
- 4 -