Maintenance; Electrical And Mechanical Troubleshooting; Error Messages - ADC EcoWash EWH-25 M Manual De Uso Y Mantenimiento

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

6.1 Electrical and mechanical troubleshooting

Before calling the Technical Service Centre, check the

following:

that power is supplied to the machine.

the condition of the fuses.

that the voltage is correct for the machine.

If the washer extractor fails to obtain the required

level of water, check:

that the water mains tap is open.

that the water inlet filter is not blocked.

that the water pressure is between 2 and 4 kg/cm

and 56 psi).

If the washer extractor vibrates excessively, check:

None of the panel screws is loose.

Message

Possible causes

This message appears on recovering the power after having been cut-off.

PWR FAUL

If the power cut occurs during the spin cycle, the message "WAIT" is

UAIT

displayed. For safety reasons, wait approximately 1.5 minutes without

pressing anything until "PWR FAULT" is displayed.

FAULT LOCK

This message appears when it is detected that the door can not be unlocked

at the end of the program or that it has unlocked during the program.

FAULT DRAIN PIPE

This message is displayed when, in spite of deactivating the emptying valve

output, the water level inside the drum has not decreased for a pre-

established period of time.

FAULT WATER INLET

This message appears when, in spite of activating the corresponding

solenoid valves' outputs, the water level inside the tub has not increased

during a certain pre-established period of time.

HEATING FAULT

This message is shown when, in spite of activating the heating output, the

water temperature has not increased for a certain pre-established period of

time.

MAX. TEMP

This message is displayed when the water temperature has exceeded 95 ºC.

THERMOSTAT OPEN

This message appears when the water temperature exceeds 203ºF.

MOTOR HEATING

This message appears when the thermal protection of the washer extractor

motor is detected to have not been activated.

UNBALANCE

E10

This message appears when the final spin activates the unbalance micro

three times.

CLOTHES HOT

E11

This message is displayed when a program finishes but the water

temperature inside the tub exceeds 122ºF.

WATER IN TUB

This message is displayed when a program execution is finished but there is

E12

still water inside the tub. The door can not be opened until the water is

drained from the tub.

If the washer extractor is set to COIN MODE or CP MODE, the door will unlock, after the safety time has elapsed, in

the event of the following errors: PWR FAUL, E2, E9 & E10.

MAINTENANCE

Only qualified personnel should maintain this equipment.

(28

If a power cut occurs, check:

The tub is drained and the door is blocked. If you want

to take the clothes out of the washer extractor, unlock

the door by pulling down the belt located behind the

front panel.

6.2 Error messages

On the washer extractor screen, warning or fault

messages may be displayed during or after the

execution of a wash program. Except in the event of a

power cut, the washer extractor will be paused (drain

pipe off, motor off, etc.) awaiting user action.

Action

Press START: the program continues to

operate in the same cycle as before the power

cut.

Press ESC: the program ends.