Warranty And Liability; Safety Instructions - SATA multi clean 2 Instrucciones De Servicio

Ocultar thumbs Ver también para multi clean 2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating instructions SATA multi clean 2
EN
Target group
This operating manual is intended for
■ Painting and varnishing professionals.
■ Trained personnel for varnishing work in industrial and craftman's work-
shops.
2.1. Accident prevention
As a basic principle, the general and specific national accident prevention
regulations must be heeded, together with corresponding workshop and
industrial safety instructions.
2.2. Replacement, accessory and wear-and-tear parts
In principle, only original replacement, accessory and wear-and-tear parts
from SATA are to be used. Accessories that were not delivered by SATA
are not tested and not approved. SATA assumes no liability whatsoever
for damages incurred due to the use of unapproved replacement, acces-
sory and wear-and-tear parts.

2.3. Warranty and liability

The SATA General Conditions of Sale and Delivery and further contractual
agreements, if applicable, as well as the valid legislation at the time apply.
SATA is not liable in case of
■ non-adherence to the operating manual.
■ use of untrained personnel.
■ unintended use of the product.
■ personal protection gear not being used.
■ original accessory and spare parts not being used.
■ independent conversions or technical changes.
■ natural wear and tear.
■ abnormal impact.
■ impermissible assembly and disassembly work.

3. Safety Instructions

Read and comply with all directions listed in the following. Non-compli-
ance or incorrect compliance can lead to malfunctions or severe injuries
and even death.
22

Publicidad

Tabla de contenido
loading

Tabla de contenido