How To Charge - Lionelo care Twee Go Manual De Usuario

milk may lose its nutritional properties.
NOTE
1.
To freeze milk, make sure ¾ of the container is filled because frozen milk expands.
2.
To maintain nutritional values of the milk while defrosting, at first place
the milk in the fridge, and then heat up with warm water at the maximum
temperature of 37°C.
3.
Do not use microwave or boiling water to defrost milk to avoid loss of
nutritional properties.
4.
Never try to freeze milk again if it has already been defrosted.
5.
Never add fresh milk to frozen milk.
6.
Before you start breastfeeding, gently shake the milk container to mix it properly.

How to charge

1.
The breast pump has a built-in battery.
2.
When the battery is low, battery symbol will show one bar. In such case it
is advisable to charge the device.
3.
Connect USB cable to breast pump USB power supply and the other tip to
the USB power adapter (not supplied).
4.
When the battery is full, battery symbol glows and shows three bars.
5.
You can use the breast pump while charging the battery, but please remain
very careful.
Troubleshooting
Problem
Device does not work
Insufficient suction
power
Pain or discomfort
How to clean and disinfect
1.
After use, disassemble the breast pump and clean the main device with a dry
and soft cloth.
EN
Solution
• Check battery status
• Start charging the device
• Make sure the device has been correctly connected to charging source
• Make sure the suction valve is correctly installed
• Place the valve in boiling water, leave for 3 minutes and then fix again
• Make sure battery level is sufficient
• Make sure the breast pump adheres to the breast tightly
• When temperature in the room is lower than 15°C, leave the working
device for about 30 seconds before you start using it.
• Adjust massage/suction level
• Change position or location of the breast
• In case the pain or discomfort does not subside, contact your doctor
‑ 8 ‑