Installation Instruction - Lionelo Truus Slim Manual De Usuario

Installation places
This product is suitable for indoor places, such as bedroom, kitchen, stairs, hallways
etc (fig. 3).
1.
A gate is siutable to installation in the passages having a width of 75 cm
to 85 cm. Installation in the wider aisles require special extensions. The
maximum width of the passage, which can be secured by using this barrier
is 105 cm. Therefor, please use two additional extensions (10 cm each)
which are included.
2.
Please make sure the set up surface is flat, strong and stable.
3.
Please make sure the set up surface is larger than 3cm.

Installation instruction

1.
Insert 4 expansion bolts into the mounting holes on both sides of the railing
(in the lower and upper part).
2.
Apply 3M tape to the flat part of the adapters and attach them to a mounting
surface larger than 3 cm in diameter with screws. Then set the railing so that
the expansion bolts are inside the plastic adapter (Fig. 4).
3.
The screws should be tightened so that the rubber washers fit tightly to the
adapters and these to the mounting surface (Fig. 5).
4.
Screw the bottom adjusters, let the gate stand vertical (fig. 6).
5.
Screw the top adjusters, let the lock close smoothly (fig. 7).
6.
Check the 4 adjusters, make sure the gate is setting up firmly (fig. 8).
7.
Extensions instalation (fig. 9).
Before you use the product, make sure the rail has been properly mounted.
Gate usage instruction
Way of open:
Press the two buttons and pull down at the same time.
1.
Move the button indicated in the illustration (fig. 10).
2.
Then raise the movable element of the barrier (fig. 11).
3.
The gate can now be opened.
•
open space 180° (fig. 12)
•
two ways openthe gate can stop at 90 degree (fig. 13)
‑ 5 ‑ EN