Adjusting The Harness - Ryobi OP40BP Manual Del Operador

ADJUSTING THE HARNESS

See Figures 9 - 10.
Straps should be adjusted to a comfortable position before
operating a tool.
To adjust shoulder and waist straps:
 Connect the battery box to the adjustable harness.
 Slip an arm through each of the shoulder straps and place
the backpack on your shoulders.
 Secure the waist strap.
 Tighten or loosen the straps until the backpack rests
comfortably against the small of your back and the straps
are snug against your waist.
 Once the harness feels comfortable, secure the chest
strap.
USB DEDICATED CHARGING PORT
See Figure 11.
The USB dedicated charging port provides charging power
of up to 2 Amps for your cell phone, MP3 player, tablet, or
other USB devices.
NOTICE:
Attempting to charge devices rated more than 2 Amps
could damage the USB dedicated charging port and/or
the device.
 Install one or more battery packs into the backpack, and
close the battery cover.
 Connect one end of a USB cable (not provided) to your
USB device.
 Connect the other end of the USB cable (not provided) to
the USB dedicated charging port to begin charging the
device.
NOTE: The USB dedicated charging port provides power
only; it does not provide any communication capabilities.
 When the device is fully charged, disconnect it from the
backpack.
OPERATION
COMPATIBLE RYOBI 40V PRODUCTS AND
TOOL CATEGORIES
WARNING:
Read and understand entire Operator's Manual for each
product or tool using the adaptor and follow all warnings
and instructions. Failure to follow all instructions could
result in electric shock, fire and/or serious personal injury.
WARNING:
The adaptor is designed to be used only with the products
or tool categories that are specified in this Operator's
Manual. It is not designed to be used with 40V mowers
or 40V ground mount products. Use of other products
or tool categories could cause serious personal injuries
or property damage.
For the list of compatible tools see the tool/appliance/battery
pack/charger correlation supplement 988000-842.
INSTALLING THE ADAPTOR INTO A TOOL
See Figure 12.
WARNING:
Always remove adaptor from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing adaptor will prevent accidental
starting that could cause serious personal injury.
To install adaptor:
 Place the adaptor in the tool. Align raised ribs on adaptor
with grooves in the tool's battery port.
WARNING:
Make sure the latch on the bottom of the adaptor snaps
in place and the adaptor is fully seated and secure in the
tool's battery port before beginning operation. Failure to
securely seat the adaptor could cause the adaptor to fall
out, resulting in serious personal injury.
To remove adaptor:
 Press and hold the latch at the bottom of the adaptor.
 Remove adaptor from the tool.
7 — English