Assembly Instructions - allen+roth GAT17001ES-L Manual

ASSEMBLY INSTRUCTIONS

1. Assemble The Holder
Attach the gas bottle clamp together with the frame.
Hardware Used
AA
M4 x 10 mm Screw
2. Assemble Holder Onto Regulator/Valve
and Table
1. Mount the body into standard table umbrella hole;
2. Attach and screw the gas bottle holder into
valve/regulator, where is to be attached onto table.
Part Used
H
Wheel Lock
3. Connect Gas Bottle Into Regulator
Caution: Only cylinders marked "propane" may be used.
Some 1-lb cylinders may form frost when near empty.
To complete assembly you will need:
(1) 16.4 oz LP gas tank (not included).
(2) Check for Leaks before operating.
1. Before connecting, be sure there is no debris caught
in the head of the LP gas tank, head of the regulator
valve or in the head of the burner or burner ports.
2. Make sure the control knob is in the " OFF" position;
3. Insert and Rotate gas bottle clockwise until they fit
snugly together. HAND TIGHTEN ONLY.
Be careful not to crossthread when screwing in tank.
1
x 2
2
x 1
3
8
G
AA
E
Table
H
H
Wheel Lock
Gas Bottle