Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE YOU BEGIN
Before using the EvolutionX
Rechargeable 4-in-1 Wine Center for the first
time, we recommend that you wipe the unit with a
clean, damp cloth to remove any dirt or dust. Dry
it thoroughly with a soft, absorbent cloth.
CHARGING YOUR WINE
CENTER/BATTERY USE
The batteries in your EvolutionX
Rechargeable 4-in-1 Wine Center have not
been fully charged. Before the first use of this
appliance, the batteries must be charged until
the blue battery indicator light illuminates.
With a full charge, your wine center will run
for approximately 20 minutes, depending on
load. Your wine center will be fully charged in
approximately 2½ hours.
Battery Life Indicator Lights: When the unit
displays 3 blue power lights, you are between
100% and 75% of battery power. Two blue power
lights: When illuminated, you are between 75%
and 25% of battery power. One blue power light:
When illuminated, you are at less than 25% and
will need to charge soon.
NOTE: Do not leave your wine opener uncharged
for an extended period of time, as it will affect the
life of the rechargeable battery.
FOIL CUTTER
For your convenience, this unit has a foil cutter,
which is stored in the base of the unit. Before
removing the cork, you must remove any foil from
the bottle. Attach foil cutter to the top of the wine
bottle. Keep hand on lower part of the bottle
and turn foil cutter with a twisting motion to cut
into foil. Remove foil to expose top part of cork
surface.
CAUTION: Blade on foil cutter is sharp. Please
keep fingers away from cutter's sharp edges.
TO OPERATE YOUR
WINE OPENER
Place the automatic wine opener on top of
the wine bottle and apply pressure. The wine
mechanism will begin to remove the cork from
the bottle and will stop once the cork has been
fully removed from the bottle and wine opener.
1.
Place the wine opener on top of the wine
bottle, making sure that it remains as straight/
upright as possible at all times. If you hold
Cordless
™
Cordless
™
the automatic wine opener at an angle to the
bottle, it will not remove the cork properly.
2.
Hold the wine opener firmly and press down
with the wine opener on top of the wine
bottle. The corkscrew spiral will turn in a
counterclockwise direction and enter the cork,
then gradually remove it from the bottle. When
the automatic mechanism has stopped, the
cork has been fully removed from the bottle.
3.
The cork, itself, will then automatically remove
from the wine opener
TO OPERATE YOUR
WINE PRESERVER
1.
Place the wine bottle on a flat surface.
2.
Insert the bottle stopper into the wine bottle.
3.
This is how the wine opener becomes a wine
preserver. Hold the bottle stopper and wine
bottle neck securely in one hand and place
the wine opener on the bottle stopper.
4.
Keep the wine preserver as straight as
possible and in line with the wine bottle.
5.
Push down on the bottle stopper. Apply
pressure and the wine preserver will begin to
work. It will automatically remove the air from
the bottle while making a clacking noise.
6.
The clacking noise will become slower
and stop suddenly after approximately
20 seconds.
7.
Do not release the pressure until the
unit stops.
8.
Remove the wine opener and stand it in the
upright position until it is needed again.
9.
After sealing the wine bottle, store bottle in
the upright position, as wine may leak if it's on
its side.
NOTE: During the above process, the wine
opener may attach itself to the bottle stopper. In
this case, hold the bottle stopper and the neck of
the bottle securely in one hand and tilt the wine
preserver away from the bottle stopper to break
the suction. This should prevent air from re-
entering the bottle. If in doubt, repeat the above
operating process.
Suggestion: For more than half a bottle of wine
remaining, one session should suffice. For less
than half a bottle, we suggest you follow the
steps above a second time.
5
Publicidad
Tabla de contenido
