Worx WU641 Manual De Instrucciones página 9

SYMBOLS
Read the manual
Warning
Double insulation
Wear eye protection
Wear hearing protection
Wear dust mask
Finishing Sander
13L-WU641-M-070305¸ÄFÓïCE´¦.indd 9
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
1. ON /OFF SWITCH
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON
Depress on/off switch (1) then lock-on button
(2)(See A), release on/off switch first and lock-
on button second.Your switch is now locked
on for continuous use.To switch off your
sander just depress and release the on/off
switch.
3.VARIABLE SPEED CONTROL DIAL
Adjust the dial(3) to increase or decrease the
speed according to the material and sanding
sheet specification to be used (also possible
during no load operation)(See A). See the
table below for general guidance on speed
selection. Avoid prolonged use at very low
speed as this may damage your sander's
motor.
Sanding wood
Sanding aluminium
Sanding metal and
Sanding plexiglass
4. HAND GRIP AREA
You can operate your sander with two hands
(See B).
5. CHANGING STANDARD SANDING
PAPER
To remove the sanding paper, lift up the clamp
lever and move away from the clamp lever
lock (See C.1).The sanding paper clamp is
now loose. Repeat with the other clamp on
the opposite side of your sander.To fit new
Grain
Sanding work
Coarse Precision
sanding sanding
Sanding down 180
varnishes
Stipping paint 40
Touching up 120
paintwork
60
Machining vener 180
80
Derusting metal 40
120
steel
180
Speed
setting(opm)
09
400 8700~11000
120 9800~11000
120 7600~10000
240 7600~11000
400 8700~11000
240 7600~11000
120 9800~11000
240 9800~11000
400 6500~8700
ENG
3/5/2007 4:11:54 PM