Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
FM RADIO MODE
-
Select FM mode on the amplifier
NOTE: to use this mode, you need to connect an antenna to FM ANT on the back panel.
-
Perform an automatic tuning of the stations to start using this mode.
-
Once finished, you can select the station you wish to listen to from among those already set.
-
If you wish to customise the list of stations stored in memory, you can do so via the menu options. For
more information, please refer to the MENU section
USB MODE
-
Connect the USB device and select USB mode.
-
Once the mode is activated, playback will start automatically.
BLUETOOTH MODE
-
Select BLUETOOTH mode on the amplifierto pair your smartphone or tablet from which you want to send
audio. To do this, use the PAIR buttonon the remote control or the PAIR option on this menu.
-
On your smartphone/tablet, turn on Bluetooth mode. Finally, search for and select the AS-170PLUS
device.
-
Select the music on your smartphone/tablet and start playback.
-
Make sure your smartphone/tablet is loud enough to be heard through the amplifier. This allows you to
control the volume from the amplifier itself at a later time without having to operate any other equipment.
MODE AUX 1/AUX 2/AUX 3/PHONO/OPTICAL/COAXIAL
-
Select the desired mode by having the signal connected to the corresponding connector input on the
rear panel of the amplifier.
-
Activate the audio device (player, mixer, PC, smartphone, etc.) connected to the input to start playback.
-
Make sure that the signal from your audio device is loud enough to be heard through the amplifier. This
allows you to control the volume from the amplifier itself at a later time without having to operate any
other equipment.
CONNECTION
-
IMPORTANT: It is important that the stage cools properly to ensure that the location where it is installed
has access to an airflow and that the chassis holes are free of obstacles.
-
With the amplifier switched off, connect all audio sources. If you are going to use the FM radio, you will
need to connect an FM reception antenna.
-
Connect the speakers to the low impedance output (SPEAKER OUTPUT*) by making the desired groups
or for an active amplifier or speakers (LINE + SUB).
*IMPORTANT: use the proper power, impedance and frequency limits for proper operation and
performance of the equipment. Before connecting to other equipment, be aware of the conditions
required in a LOW IMPEDANCE installation. More information can be found at:
-
Turn on the amplifier and select the input with the INPUT control.
-
Finally, adjust all volume and equalization controls (BASS and TREBLE) and make the desired settings
using the menu.
fonestar.com/downloads/install_fonestar_es.pdf
- 6 -
Publicidad
Tabla de contenido
