Tabla de contenido
Publicidad
16 PIN CONNECTOR PINOUT
HARDWARE INSTALLATION
1. Unscrew two back panel hex bolts and remove the back panel.
2. Insert your SIM card(s) into the SIM socket(s), which are located on
the bottom side of PCB.
3. Attach the panel and tighten the hex bolts.
4. Attach the mobile antenna (max torque 0.4 N·m / 3.5 lbf·in).
5. Connect the 16 pin terminal block with power adapter to the 16
pin connector on the front panel. Then plug the other end of the
power adapter into a power outlet.
All manuals and user guides at all-guides.com
+ - 9-30 VDC positive power pin
D1, D2, D3 - Configurable digital Input/Output pins. Open
collector output, max output 30 V, 300 mA or Digital input
where 0-6 V detected as logic low and 8-30 V – logic high.
CTS - RS232 clear data to send pin (output).
RTS - RS232 request data to send pin (input).
R+ - RS485 receiver positive signal pin.
D+ - RS485 driver positive signal pin.
- - Negative/ground power pin.
- Ground pins for D1, D2, D3, A, RS232 and RS485.
A - Analog input pin. Analog voltage range 0-30 V.
TX - RS232 transmitted data (input).
RX - RS232 received data (output).
R- - RS485 receiver negative signal.
D- - RS485 driver negative signal.
SIM1
SIM2
Publicidad
Tabla de contenido
