Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
Maximum flow rate: 1.8 GPM (6.814 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF/ANSI/CAN 61
Chrome and stainless steel finishes
INSTALLATION INSTRUCTIONS
1. Shut off the water at the supply
valves under the sink or at the
main water supply. Disconnect
the supply lines. Remove the
existing faucet from the sink.
Clean and dry the surface area
where the new faucet will be
mounted.
2. Insert the spout (A) with the
attached o-ring (2.1) into the
faucet body (B). Hand tighten
the spout nut (2.2) into the faucet
body (B) until the o-ring (2.1) is
pressed firmly into place in the
faucet body (B).
Note: The o-ring (2.1) comes
attached to the spout (A).
3. Wrap thread seal tape (3.1) in a
clockwise direction to cover the
exposed male threads on each
1/2-inch stub out pipe (3.2)
extending from the wall. Screw
the flanges (E) onto the fine
threaded side of the swivel unions
(D), with the flat side facing away
from the sink. Use a wrench to
tighten each swivel union (D)
onto each 1/2-inch stub out
pipe (3.2).
OPERATING INSTRUCTIONS
The lever handles control the flow of hot and cold water to the faucet. Rotate the right handle forward for cold water. Rotate the left handle forward for
hot water. Moving the handles forward opens the cartridges and causes water to flow from the spout. The degree of handle opening determines the
volume of water flow. Returning the handles to the original position stops the flow of water.
CARE AND CLEANING
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.
1
2
A
2.2
2.1
B
3
3.2
3.1
E
D
Ceramic cartridges
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
4.
Insert a rubber washer (F) into
each union nut (4.1) on the
faucet body (B). Tighten the
union nuts (4.1) to the swivel
unions (D) using a wrench.
5.
Once the installation is com-
plete, remove the spray head
(C) from the spout (A) on the
faucet body (B) to flush the
water lines. Turn on the water
supply and allow both hot and
cold water to run for at least
one minute to flush away any
debris that could cause damage
to internal parts. While the water
is running, check for leaks. If a
leak occurs, gently tighten the
nut on the connection that is
leaking.
Turn off the water and screw
the spray head (C) back onto
the spout (A) of the faucet
body (B).
2
4
F
4.1
B
5
A
B
C
Homewerks.com
D
Publicidad
Tabla de contenido
