Cleaning And Care - Powerfix Profi PPR 4 B2 Instrucciones De Uso

NOTE
► The overflow seal
overflows. If the overflow seal
close the overflow, use a cloth or something
similar to seal it.
WARnInG In REGARD To pRopERTy
DAmAGE!
Use this appliance only on drains and pipeworks
able to withstand pressure. Support poorly
seated pipes against the floor! If you do not, the
pressure surge could damage the pipe.
4. Close the plughole with a stopper and and
pour some warm water into the bowl (up to
about 7 cm above the plughole). The best
possible pressure effect is achieved only
when the blocked pipe is completely filled
with water. Without water in the pipe the
pressure effect is strongly reduced.
5. Build up a little pressure, in that you
activate the pump
times. If you pump too slowly, the air could
escape from the appliance.
6. Remove the stopper and place the appli-
ance, as shown in Fig. 6, on the plughole.
Fig. 6
■ 10 │ GB │ IE
All manuals and user guides at all-guides.com
does not fit in all
cannot
quickly about 3 - 4
7. Then release the pressure surge.
When doing this, press the appliance firmly
against the plughole.
8. If the blockage is not released, and you
are sure that the pipe can withstand the
pressure, increase the pressure for the next
pressure surge.
9. Take the appliance out of the water and
activate the pump
times.
10. Should you wish to release some pressure
from the appliance, unscrew the air release
valve .
11. Place the appliance back onto the plughole
and activate the pressure surge.
ImpOrTaNT
► Repeat these pressure surges only for as
long as the water level is above the plugho-
le. If necessary, refill with water.
12. Repeat the pressure surge until the blockage
is cleared.
NOTE
► Should you not be able to build up pressu-
re, check the air release valve
that it is firmly screwed onto the appliance.

cleaning and care

■ Clean the attachments
the housing with a moist cloth. For stubborn
soiling use a mild detergent on the cloth.
ATTEnTIon! AppLIAncE DAmAGE!
Do not use aggressive, abrasive or chemical
cleaning agents to clean the appliance or its
attachments / / / . These could damage
the upper surfaces.
NOTE
► The white powder on the pump
soiling. It is a talcum powder that was used
in the factory for the first pump lubrication.
rapidly about 10
. Ensure
/ / / and
is not
PPR 4 B2