Grease filters
To avoid possible burns clean them thoroughly once a month or when the light indicator warns
it. For this, remove the filters and wash them with hot water and detergent. Do not use brigh-
tener. If using a dishwasher (metal parts may turn black without this affecting their functional
capacity), load the filters vertically to avoid solid residue from being deposited.
Replacing the bulbs
Warning: do not handle bulbs until the main power is off and their temperature have
decreased.
Important: use new bulbs as indicated in the hood rating plate.
If using LED lighting, do not look directly at the light.
Use bulbs with aluminium reflector to replace halogen lamps. Do not use dichroic bulbs - risk
of overheating.
For LED lamp replacements, please contact Technical Support or the distributor of the brand.
Problem
Bulbs do not work.
The motor works, but it seems to have
lost performance or exhausting capacity.
The hood does not work.
The hood does not work yet
60820920.08.06.2021.indb 22
60820920.08.06.2021.indb 22
EN
Cause / Solution
It may be necessary to replace them, but you must pre-
viously check that the lamp is adequately placed and the
contact is correct. Remember that bulbs are not covered by
the warranty. Disconnect the current hood before handling
the bulbs. Use bulbs with the same properties described in
the rating plate. It is recommended to use bulbs supplied
by the hood manufacturer.
The selected speed is too low / Select a higher speed
Review the metal filter (grease filter). If not washed recent-
ly, it can be obstructed with grease or dirtiness. Remove it
and wash it in hot water and detergent, and allow to dry
before assembling it again.
Make sure that the outlet air tube it not obstructed.
Check that the hood is connected to the power supply.
Check that fuses or the automatic switch have not blown.
If the problem is not solved after checking the above items,
contact the technical service or your dealer.
22
FAQS
30/6/21 9:08
30/6/21 9:08