Leggett & Platt G-SMR-2 CUSTOM Manual De Operaciones página 8

g-smr-2 custom remote controL programming (1 remote control - 2 bases)
Program One Remote to Operate Two Bases - your adjustable
base will be equipped with one of the following: (A) a DC motor
with a power down box, (B) an AC J box, (C) a DC motor without
a power down box (FIGURE 2).
a
LEARN
BUTTON
b
AC J BOX
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
c
DC MOTOR-NO
POWER DOWN
BOX
FIGURE 2: Power down box, AC J box and DC motor.
step 1
(A) DC motor with a power down box: press
the learn button on the power down box for 1
second.
(B or C) AC Jbox or DC motor without power
down box: unplug the adjustable base electrical
power cord. Wait 30 seconds, then plug the
cord back into the power source.
step 2
On the remote control, simultaneously press
and hold the POS 1 and head massage on/off
buttons (FIGURE 3). The transmission indicator
light will flash slowly and then flash rapidly to
indicate programming mode. Continue to hold
for 5 seconds and then release the buttons.
8
G-SMR-2 Custom Remote Control Operation Guide 99300822-e
POWER DOWN
BOX (NOT
POWER
MOUNTED TO
DOWN BOX
BASE FRAME)
LEARN
BUTTON
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
step 3
Repeat Step 1 and Step 2 with base 2.
One remote control is now programmed to
operate two bases.
POS 1
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
FIGURE 3
BASE 1
BASE 2
TRANSMISSION
INDICATOR LIGHT