Legal Information The Manufacturer: - Declares That This Appliance Complies - Edesa 932271899 Manual De Instrucciones

existing standards.
If the appliance is not equipped with a plug,
connect the appliance directly to the power
grid, protected by an omnipolar separating
device which can be accessed to disconnect
it, in accordance with local regulations.
If the power cable is damaged, it must be
replaced by the manufacturer through its
post-sale service, or by similar, qualified
personnel in order to prevent danger.
Using the hood - Safety
Warning: during electrostatic discharge
(e.g. a flash of lightning) the hood may
stop working. This does not involve risk of
damage. Shut off the power supply to the
hood and re-connect it after one minute.
Children under the age of 8 years should be
kept away from the appliance unless under
permanent supervision.
This appliance can be used by children of
8 years and over and people with reduced
physical, sensory or mental capacities
or a lack of experience or knowledge, if
supervised by a person responsible for their
safety or if they have been given suitable
instructions regarding the safe use of the
appliance and they understand the risks
involved. Children should not play with the
appliance. The cleaning and maintenance
to be performed by the user should not be
carried out by unsupervised children.
To avoid the risk of fire, the metal filter should
be cleaned regularly.
Containers with hot oil should be monitored
continuously.
Do not set food alight under the hood.
Accessible parts may become hot when
used with cooking appliances.
Legal information
The manufacturer:
- Declares that this appliance complies
with the essential requirements for low-
voltage electrical equipment, as set out in
Directive 2014/35/EU, and electromagnetic
compatibility, as set out in Directive 2014/30/
EU.
- Shall not be held responsible for failure to
follow the instructions given in this manual
or non-compliance with safety standards
relating to the correct use of the equipment.
- Shall not be held responsible for any
damage caused by the incorrect installation,
use or maintenance of the appliance.
- Reserves the right to make any changes to
the equipment or this manual without giving
prior notice.
Should you need technical assistance or
additional information about our products,
please contact your distributor or an official,
authorised technical service.
Hood installation on walls
Notes: The figures mentioned in this manual are in the first pages.
If the height from the Hob to the hood in the instruction user manual of the hob
supplier is higher than the hood template, follow adhere to the hob supplier info.
For gas cooking appliances only: the minimum distance to the hood must be at least
65 cm.
The screws and bolts supplied for attaching the hood to the wall are for solid masonry
walls. For other types of wall, the suitable means should be used.
Use a rigid PVC pipe with a min. Ø l20 mm to evacuate fumes outside.
It is recommended that there are no bends in the outlet tube, and that there is a
distance of less than 1 metre between the hood outlet and the bend.
The above restrictions do not apply to hoods with no fumes outlet to outside
(recirculation system with activated charcoal filter).
Use of the hood - Control panel
The different control panels are described below. Check the panel model installed on
your hood and see the figure indicated in each case.
Five-button panel (Fig. P1)
1- Extractor fan operating control pilot light.
2- Lighting on and off.
3- Extractor fan off.
4- Extractor fan speed - button: speed 1, 2 and 3,
Touch panel (Fig. P2)
1- Filter clean warning display/button. Warning of the need to replace the
filter – press to deactivate once the filter has been cleaned or replaced.
2- Enable and disable extractor fan timer.
3- Lighting on and off. Keep pressed down to adjust the lighting intensity.
4- Extractor fan on and off.
5- Extractor fan speed - button: speed 1, 2 and 3/4. In panels with TURBO (T)
button, Turbo speed only will work during 5 minutes, once it runs out, the
speed will decrease to 3rd speed.
Timer: the extractor fan works for 5 min. at the current speed and another 5
min. at each of the lower speeds until it stops.
INSTALLATION
The hood may be installed to work in two different ways: If there is a possibility of
installing the hood with an evacuation pipe to the outside, it will be used in aspirating
version. If this possibility does not exist, the hood will be used in the filtering version,
8