Disassembling And Cleaning - Makita DTR181 Manual De Instrucciones

Disassembling and cleaning

1.
Loosen bolts A and B using the hex wrench
included in the tool package.
► Fig.52: 1. Hex wrench
► Fig.53: 1. Bolt A 2. Bolt B 3. Contact plate cover
4. Wire guide B
NOTICE:
Do not forcibly remove any bolts that
cannot be removed using the hex wrench.
2. Pull the contact plate cover up in the direction of
the arrow and remove it. Bolt B will be removed at the
same time.
► Fig.54: 1. Contact plate cover 2. Bolt B
3. Remove bolt A, and remove wire guide B.
► Fig.55: 1. Bolt A 2. Wire guide B
4. Turn wire guide B over and clean its inside.
► Fig.56
5. Remove top plate, cutter B, link arm A and cutter A
from arm plate A. Then, clean them.
► Fig.57: 1. Top plate 2. Cutter B 3. Link arm A
4. Cutter A 5. Arm plate A
Assembling
When cleaning is finished, assemble the parts accord-
ing to the following procedure.
1.
Install cutter A and link arm A to fit the shape of
arm plate A.
► Fig.58: 1. Cutter A 2. Link arm A 3. Arm plate A
2. Install cutter B and the top plate onto arm plate A.
(Install cutter B on cutter A and link arm A.)
► Fig.59: 1. Cutter B 2. Top plate 3. Arm plate A
4. Cutter A 5. Link arm A
NOTICE:
Face the projection of cutter B down-
ward, and install the cutter as shown in the figure.
3.
Align the pipe of the tool with the groove inside the
wire guide B, and assemble them.
► Fig.60: 1. Pipe 2. Groove 3. Wire guide B
4. Fix wire guide B by temporarily tightening bolt A.
► Fig.61: 1. Bolt A 2. Wire guide B
5.
Install the contact plate cover in the direction of
the arrow.
► Fig.62: 1. Contact plate cover
6. Fix wire guide B and contact plate cover securely
by tightening bolt A and bolt B.
► Fig.63: 1. Wire guide B 2. Contact plate cover
3. Bolt A 4. Bolt B
7. After assembling, confirm that the contact plate
can move as shown in the figure.
► Fig.64: 1. Contact plate
NOTE: If the contact plate is caught, press it as
shown in the figure.
► Fig.65
21 ENGLISH