Orima ORC 60630 T Libro De Instrucciones página 17

INSTALLATION
WALL DRILLING AND BRACKET FIXING
Vertical reference line
As a first step, proceed with the following drawings:
 A vertical line up to the ceiling or up to the upper limit, at the center of the area in which the
hood is to be fitted.
 A horizontal line A at 950 – 1050 mm above the cooker top.
 A horizontal line B at a X mm above the horizontal line A.
 A horizontal line C at a Y mm above the horizontal line B.
Mark Points:
 Mark a point (1) on the horizontal line A, 80 mm to the vertical reference line.
 Repeat this operation on the other side and on the vertical reference line, checking that the
three marks are leveled.
 Mark a point (2) on the horizontal line B, 60 mm to the vertical reference line.
 Repeat this operation on the other side , checking that the two marks are leveled.
Mark a point (3) on the horizontal line C, 60 mm to the vertical reference line. Repeat

this operation on the other side , checking that the two marks are leveled.
Fix the brackets :
 Drill holes at the marked points with a ɸ10 mm drill bit.
 Insert the Wall Plugs 11 into the holes.
 Fix the hood fixing bracket 20 with 3 screws 10 (5 x 50) at the horizontal line A.
 Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50) at the horizontal line C.
60
(3)
C
60
60
(2)
B
60
80 80
(1)
A
EN-5
Option Chimney X
1 400X390 129
2 500X490 229
3 560X560 289
Y
50-350
50-450
50-520