Call Setup - 2N D7A Guía Rápida

Call Setup

Using the handset:
1. Pick up the handset.
2. Dial a number and press Call.
Using the speakerphone:
1. Press
2. Dial a number and press Call.
Using a headset:
1. Connect the headset and press
2. Dial a number and press Call.
Note: The modes can also be switched during calls by pressing
Call Answering
Using the handset:
Pick up the handset.
Using the speakerphone:
Press the
Using a headset:
Press the
Note: Press Reject to reject a call.
End of Call
Using the handset:
Hang up the handset or press End Call.
Using the speakerphone:
Press
Using a headset:
Press End Call.
Redial – Last Call Redial
• Press to enter the list of Outgoing calls, then click the contact to select the required number or press
• In the idle state, press
Call Mute and Mute Cancel
• Press during a call to turn off the microphone.
• Press again to cancel mute.
Call Hold and Release
Call Setup during Hold: Press
To continue a call, perform the following: If just one call is being held, press
Call Transfer
Transfer without consult (blind)
1. Press
2. Select the number to which the call is to be transferred.
3. Press
Transfer with consult
1. Press
2. Select the number to which the call is to be transferred and press #SEND.
3. Press
5
in the idle state.
button.
button.
or End Call.
twice to redial the last called number.
or the Hold button during a call.
or the Transfer button during a call. The call will be held.
or the Transfer button.
or the Transfer button during a call. The call will be held.
or the Transfer button.
to activate the headset call.
or by picking the handset.
or the Continue button.
.