INSTRUCTIONS FOR USE
1. Before using the heater, make sure that it is on a flat and stable
surface, damage may occur if it is placed on an incline or decline.
2. Set all the controls to OFF position and insert the plug into a socket-
outlet with well grounded. Be sure that plug fits firmly.
3. Rotate the thermostat knob clockwise to MAX position and switch
the heater on as follow: the switch I for low heat, the switch II for
medium heat and both switches on for high heat.
4. When your room reaches the desired temperature, now slowly
rotate the thermostat knob counter clockwise until the pilot light goes
out. The thermostat can now be left at this setting. As soon as the
room temperature has dropped below the set temperature, the unit
will switch it self on automatically until the set temperature has been
reached again. In this way the room temperature remains constant
with the most economical use of electricity.
5. If you want to change the room temperature setting, rotate the
thermostat knob clockwise to raise the temperature, or counter
clockwise to lower it.
6. This heater includes an overheat protection system that shuts off
the heater when parts of the heater are getting excessively hot.
7. To completely shut the heater off, turn all the controls to OFF, and
remove plug from the socket-outlet.